Tag: safety edge

DorEdge Controller 12V

The DoorEdge Optosensor Controller is a Safety Edge single processing and monitoring unit which interfaces between the Tx and Rx optical sensors and the Motor controller unit. The system is continually monitoring for compression of the doors rubber profile as well as cable faults.

Technical Specifications Electrical

  • Supply voltage:
    • 12–24V AC/DC (from control panel)
  • Current consumption:
    • Low (<100 mA typical)

The controller forces the system into a safe state (door stops / won’t close)


(The Company reserves the right to amend product specifications and information without notice.)

Downloadable Resources

Download Manual

Marantec Optosensors – for Marantec Safety Edge Device

The optosensor is an optical transmitter receiver kit which fits into a hollow rubber profile which is mounted on the leading edge of a door.  Any contact with an obstacle that causes deformation of the hollow rubber is identified by the door operator as an obstacle.  The door stops and reverses.

Specs:

  • Protection rating: IP68 (fully dust & water resistant)
  • Operating temp: -20°C to +55°C
  • Signal type: transmitter/receiver system inside rubber edge
  • Cable lengths: ~10 m TX / 1m RX typical

(The Company reserves the right to amend product specifications and information without notice.)

Downloadable Resources

Download Spec Sheet

MARANTEC PROTECT-OPTO 502 Wireless Closing Edge Safety Device

Wireless closing edge safety device for sectional doors and sliding gates with fast installation and two-channel transmission.

Specifications: Wireless Transmission; Simple and fast installation; Two-channel system; Protection: Tx: IP55

FEATURES
  • Wireless transmission
  • Simple and fast installation
  • Two-channel system
  • Includes 2 batteries
  • May be selected via DIP switch
SPECIFICATIONS
RADIO FREQUENCY 868.95 MHz or 869.85 MHz
NOMINAL VOLTAGE Rx: 5V DC
BATTERY TYPE Tx: AA 3.6V
PROTECTION Tx: IP55
CABLING Conventional
STORAGE Maximum 7 transmitters
TEMPERATURE -20º to +55ºC
RANGE 10m
MEASUREMENTS Tx: 183 x 51 x 36mm
 

 

 

(The Company reserves the right to amend product specifications and information without notice.)

Downloadable Resources

Download Data Sheet

Download Manual

Rubber Profile for Safety Edge Device

Bottom door profile (2 chambers), 29 x 58 mm for 14 mm opto-sensors.

Price per meter.

(The Company reserves the right to amend product specifications and information without notice.)

Downloadable Resources

Download Spec Sheet

Steel Profile (sold per meter)

Aluminum profile set 24×8 mm – Supplied, per meter

(The Company reserves the right to amend product specifications and information without notice.)

Downloadable Resources

Download Spec Sheet

0
0
Your Cart
Your cart is emptyReturn to Shop